UniGo Geri

  • The UniGo™ Microfluidic Pump is a precision, microfluidic, single-channel pressure pump for a variety of microfluidic applications, where accurate and stable flow rate delivery is required. The pressure pump component is based on controlled air injection. The UniGo™ pump requires a plug-and-play flow sensor for active feedback and increased flow control. SmartFlo Application executed on the iPad mini or LabView based interface communicates with up to 4 UniGo™ Microfluidic Pumps racked together allowing simultaneous control and independent programming of each pump’s flow profile. Uniquely, the UniGo™ may be docked together with the ExiGo™ microfluidic syringe pump combining the best features of both UniGo™ and ExiGo™ in one microfluidic set-up. Note: it is compulsory to purchase a flow sensor with the UniGo pump.


    • 2 modes of pumping: manual flow rate set or preprogrammed flow rate operation.

    • Preprogrammed mode includes: Constant, Ramp, Step, Sine functions.

    • Wi-Fi communication with iPad mini software.

    • USB communication with LabView based PC control software.

    • Tactile power switch.

    • LEDs for power / status information.

    • Side port connections to dock up to 4 pumps (combination of UniGo and ExiGo) into one setup.

    • Volumetric flow rates: 1 µL/min – 1 mL/min.

    Performance Specifications

    Volumetric Flow Rates 1 µL/min - 1mL/min
    Flow Direction  Unidirectional (Push)
    Pulse-free flow rate for microfluidic applications*

    • 1 µL/min – 80 µL/min ± 120 nL/min with 80.0 µL flow sensor (FS-80.0)

    • 10 µL/min – 1 mL/min ± 2 µL/min with 1.0 mL/min flow sensor (FS-1000)

    Working Pressure

    30 psi – 2 bars maximum

    Compressor Options Internal or external
    Software Control

    • SmartFlo App running on iPad mini

    • LabVIEW based PC software


    225mm x 69mm x 122mm (L x W x H)


    Approx. 1.3kg

    Power Requirements

    110 / 220V - 50 / 60Hz - 60W

    *Measured with Flow Sensor and active PID feedback

     Flow Sensor (compulsory accessory)

    Operation Plug and play connection to the UniGo Microfluidic pump
    Features Allows monitoring of UniGo pump flow rate and active PID (proportional, integral, differential) feedback of pump flow rate
    Dead volume

    1 - 25 µL depending on Flow Sensor

    Measured flow rate changes

    See Technical Note on Flow Sensors

    Max pressure

    30 psi – 2 bars maximum

    Dimensions / Weight

    60mm (L) x 51mm (W) x 21mm (H) / < 0.1 kg

    Power Requirements Via cable to UniGo Microfluidic Pump